N516 Factory Flashing

Hanvon N516

WARNING

Before flashing this firmware to device, remove existing USBBoot driver! Driver provided with the firmware has been modified to correctly work with UBI filesystem.

WARNING

How to flash:

1. Connect the device via USB.
2. Push the 'Rotate' button and power on the device.
3. New device will appear in your system, point to this directory for driver.
4. Run USB_Boot.exe
5. Execute commands in the USBboot shell:

   > boot 0
   > fconfig USBboot.cfg 0
   

   If all is OK, next messages will appear:

    USBBoot :> boot 0
   
    Booting No.0 device......UnBooted.....Boot success!
    Initing No.0 device......Init Configration success!
    USBBoot :> fconfig USBboot.cfg 0
   
    Configing No.0 device....
    Init Configration success!
    USBBoot :>
   

6. Execute next commands:

   > nerase 0 4096 0 0
   > nprog 0 n516-image.bin 0 0 -n
   

7. When flashing is complete, reset the device.

* HOW TO TEST CORRECTNESS OF FLASHING *

1. Flash the device as specified above.
2. Reset the device, wait until 'select language' dialog appears.
3. Select English language from the list.
4. Wait until menu is displayed.
5. Press 'power' button.
6. Press 'OK' when 'want to power off?' message box appears
7. Wait 5 secons
8. Press 'power' button
9. Make sure device boots and menu appears on screen.

If device does not boot properly second time, then flashing was done by using wrong USBBoot driver, reflash the device using the bundled one.

* HOW TO TEST CORRECTNESS OF FLASHING *

TO BE WRITTEN